浙江荣信电机

language
中国
韩国
韩国
韩国
韩国
韩国
NEWS
Survive by quality,Develop with benefit
/
/
/
Disassembly and assembly precautions of misting machine products

News Information

Intelligent workshop, excellent equipment, become your sincere professional partner

Check category

Disassembly and assembly precautions of misting machine products

  • Categories:misting machine
  • Author:
  • Origin:
  • Time of issue:2022-06-14 16:02
  • Views:

(Summary description)Most of the parts of the whole machine are made of light aluminum alloy and thin-walled stamping. The size of each screw and nut is small. When disassembling and assembling the misting machine products, the force should not be too large to prevent the thread from being damaged.

Disassembly and assembly precautions of misting machine products

(Summary description)Most of the parts of the whole machine are made of light aluminum alloy and thin-walled stamping. The size of each screw and nut is small. When disassembling and assembling the misting machine products, the force should not be too large to prevent the thread from being damaged.

  • Categories:misting machine
  • Author:
  • Origin:
  • Time of issue:2022-06-14 16:02
  • Views:
Information

1. Most of the parts of the whole machine are made of light aluminum alloy and thin-walled stamping. The size of each screw and nut is small. When disassembling and assembling the misting machine products, the force should not be too large to prevent the thread from being damaged.

misting machine products

2. The connection between the powder door body and the medicine box does not need to be disassembled if there is no leakage.

3. Disassembling and assembling the twelve screws of the centrifugal fan casing, the four screws connecting the engine and the back cover of the fan, and the cylinder head nuts should be loosened or tightened at the corners. In order to avoid overflow, all screws should be gently screwed into the thread and then tightened. Of all the screws, except for the left-handed hollow screws that fasten the starter wheel and the magneto flywheel, which are tightened counterclockwise, the rest are all right-handed, that is, clockwise to tighten.

4. When removing the impeller, if the impeller and the shaft, the shaft and the fastening nut are rusted, it can be soaked with gasoline for a while, then the nut is unscrewed and pulled out with a puller. Do not hit hard with a hammer.

5. When dismantling the fan impeller and fan, 3 M6 screws should be screwed into the five buttons in the screw thread at least Z, align them horizontally, apply force evenly, and then turn the thimble screws.

6. Do not overtighten the nuts at both ends of the fan support assembly to avoid damaging the rubber column.

7. When replacing the piston, it is strictly forbidden to use an iron tool to knock the piston pin out of the pin hole. First remove the piston pin retaining ring, then place the piston in the oil and heat it to about 160 ℃, and the piston pin can be pushed out gently. When installing the piston, note that the arrow on the top points to the exhaust side. If there is no arrow, make the positioning pin in the piston ring groove on the intake side.

8. When disassembling and assembling the piston ring, do not open the ring mouth too much to avoid breaking.

Keyword:

Scan the QR code to read on your phone

Copyright 2019 ©paichi.cn All Rights Reserved  

搜索
Search